Moving a gym is not a removals job. Cable machines need their stacks secured, racks come apart in a specific order, and a treadmill dropped onto its deck arrives as scrap. We dismantle, transport and reinstall properly.
How a relocation runs
-
Step oneSurvey both endsWhat is moving, and whether it can get out of the current site and into the new one. Access decides more than the inventory does.
-
Step twoPlan the new layoutThe new room is rarely the same shape. We lay it out before the move rather than improvising on the day. See Planning & Design.
-
Step threeDismantleStacks secured, cables released under control, frames broken down in the correct sequence, fixings bagged and labelled per machine.
-
Step fourTransportProtected and secured for transit. Consoles and electronics handled separately from frames.
-
Step fiveFlooring firstIf the new room needs flooring, it goes down before anything is reassembled. See Gym Flooring.
-
Step sixReassemble and testRebuilt, levelled, torque-checked and every station cycled before handover.
Worth knowing before you move
-
A move is the right time to serviceEverything is apart already — replacing worn cables and bushings now costs a fraction of a separate visit later.
-
Some equipment should not travelMachines already near end of life sometimes cost more to move and rebuild than to replace. We will tell you which.
-
Access at the new site decides everythingLift dimensions and doorway widths at the destination, not just the origin.
-
Flooring rarely comes with youBonded rubber usually cannot be lifted intact. Budget for new flooring at the new site.
-
Photograph before dismantlingUseful for insurance and for confirming condition on arrival.
-
Old site reinstatementAgree who makes good the floor and walls once equipment is out.
Common questions
Can you move a full commercial gym?
Yes. Larger floors are phased so the move happens in a controlled sequence rather than everything at once. Send us the equipment list and both addresses and we will scope it.
Can you store equipment between sites?
Tell us how long a gap you need and we will confirm what we can arrange. Do not assume it is available — it depends on volume and timing, and we would rather be straight about that upfront.
What if something is damaged in transit?
Condition is recorded before dismantling and checked on reassembly, which is exactly why we photograph beforehand. Because we dismantle, move and rebuild, there is no argument about which stage caused it.
Do you handle just part of a move?
Yes — dismantling only, or reassembly of equipment someone else transported. Tell us which part you need.
Plan a relocation
Send the equipment list, both addresses, access details at each end and your target date.
